Siemens SINUMERIK 810DE powerline - DMP compact module 1 I NC analog

8.5 DMP compact module 1I NC analog (6FC5211-0AA10-0AA0)
8-106
Copyright © Siemens AG 2006
SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition
8.5 DMP compact module 1I NC analog
(6FC5211-0AA10-0AA0)
The DMP compact module 1I NC analog is an encapsulated rapid analog input
module with 75 ms access time. It can be plugged into a slot of the NCU terminal
block as a plug-in module (maximum 4 modules per terminal block).
M2M1
P2P1
24 V DC
6, 1 Shield
2 Ground
3 Analog input In+
4 Analog input In–
5 Ground
X1
Status
LEDs
Fixing
screw
Labeling
strips
POWER
SUPPLY
OK
ANALOG
IN
Connecting terminals
X3
X2
0 V
1
3 2
1
2
S1
S2
2,5
2.5
6..1
Terminal:
Fig. 8-6 Front view and side view of a DMP compact module 1E NC analog
 A 30-pole connector X1 for connection to the NCU terminal block.
 4-way terminal X3 (Phoenix, Type MSTB2.5/4-ST-5.08 GREY, order no. for
X3: 18 48 407) for connecting the power supply for the analog part and 6x
terminal X2 (Phoenix, Type MSTB2.5/6-ST-5.08 GREY, order no. for X2: 17
87 076) for connecting the analog input.
 The terminals are pluggable and can be mechanically coded by the
customer.
1 LED as a status display for the power supply.
LED lit: internal power supply OK
Interfaces
Display elements
8 DMP Com
p
act Modules