Siemens SINUMERIK 810DE powerline - DMP Compact Module 16 O (6 FC5111-0 CA02-0 AA2)

8.2 DMP compact module 16O (6FC5111-0CA02-0AA2)
8-99
Copyright © Siemens AG 2006
SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition
8.2 DMP compact module 16O (6FC5111-0CA02-0AA2)
The DMP compact module 16O is an encapsulated module. It can be plugged
into a slot of the NCU terminal block as a plug-in module.
PM7 6 5
Outputs
OUT 7 ... OUT 0
HIGH byte
X1
43210
0 1234 567MP
Status
LEDs
Fixing
screw
Labeling
strips
Outputs
OUT 0 ... OUT 7
LOW byte
0V
X3
X2
0
.
.
7
X3
X2
LOW byte
0
.
.
7
HIGH byte
24 V
LOAD
DC 1.5
0V
24 V
LOAD
DC 1.5
M = GND
Fig. 8-2 Front view and side view of a DMP compact module 16A
 A 30-pole connector X1 for connection to the NCU terminal block.
 10-terminal X2 and X3 (Phoenix, Type MC1.5/10-ST-3.81 GREY, order no.
for X3 and X2: 18 28 171) for connecting the 16 outputs and the load power
supply.
 The terminals are pluggable and can be mechanically coded by the
customer.
16 LEDs as a status display for the logical states of the outputs.
As from product version B, the LEDs go out when the load voltage fails.
LEDs lit: Output on.
Table 8-3 Technical data of DMP compact module 16O
Number of outputs 16 digital outputs
Galvanic isolation Yes
Power supply V
LOAD
– Rated value 24 V DC
– Perm. range 20.4 V to 28.8 V
– Ripple 3.6 Vpp
Signal level of the outputs (typically)
– For signal “0” Open
– For signal “1” V
load
–250 mV
Interfaces
Display elements
8 DMP Com
p
act Modules