Siemens SIPROTEC 6MD63

Revision 4.2
Edition: April 2005
C53000-L1840-B001-03
SIPROTEC
Protection devices
7SA522, 7SA6
7SD5, 7SD610
7SJ61...7SJ64
7ST622, 7ST61, 7ST63
7UM61, 7UM62
7UT612, 7UT613, 7UT63
7VE61, 7VE63
7VK61
Input/Output unit
6MD63
Bay control unit
6MD663/6MD664
Communication module
PROFIBUS-DP
Communication profile
Preface
Table of contents
PROFIBUS Communication modules 1
Parameters and properties 2
Data type definitions 3
PROFIBUS-DP - Parameterization in DIGSI 4
Technical data 5
Index

Siemens SIPROTEC 6MD63 Specifications

General

Brand	Siemens
Model	SIPROTEC 6MD63
Category	Control Unit
Language	English

Summary

Preface

Purpose of this manual

Outlines the manual's content and structure, dividing it into specific topics.

PROFIBUS Communication modules

Communication module types and hardware revisions

Details available communication modules and their hardware versions.

Display of module-specific information at the SIPROTEC device

Explains how to view module status and parameters on the device.

Parameters and properties

Bus specific parameters

Configuration settings for PROFIBUS-DP communication, including slave address and PNO identification.

Execution of switching operations via PROFIBUS-DP

Details command output modes for single and double commands, including pulse output.

Response in the event of disturbed communication to the PROFIBUS-DP master

Handling communication interruptions and errors, including error tagging and reestablishment.

Data type definitions

Single-point indication (SP, Input)

Defines the data type for single-point status signals, including value ranges and bit structure.

Measured value (signed integer)

Defines the data type for integer-based measured values, including status bits.

Transformer tap change command (TC)

Defines the data type for transformer tap control commands and their values.

PROFIBUS-DP - Parameterization in DIGSI

Interface selection and mapping files

Choosing interface and mapping files for device configuration in DIGSI.

Customization of the allocations

Modifying how data objects are mapped and routed between SIPROTEC and PROFIBUS.

Scaling of measured values

Configuring how measured values are scaled for transmission via PROFIBUS-DP.

Technical data

Connection via the PSE module

Technical specifications for the RS485 interface connection, including line length and bus termination.

Connection via the PSO module

Technical specifications for the fibre-optical interface connection, including line length and baud rate.