Need help?Do you have a question about the Siemens SIMATIC TI505 and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | SIMATIC TI505 |
| Category | Control Unit |
| Language | English |
Details the module's counters, outputs, and operational capabilities, including 24-bit and 16-bit counter modes.
Explains the 1X, 2X, and 4X quadrature counting modes for 24-bit counters, detailing input relationships and count direction.
Details the I/O connections, wiring for user power, and backup power, including terminal block layout.
Explains how to assign the I/O starting address in the PLC memory to enable controller-to-module communication.
Details the use of WY19 and WY20 setup words for configuring counter options and modes in Program Mode.
Explains the use of WY19 and WY20 setup words for configuring counter options and modes in Run Mode.
Guides on setting preset values and programming options for Channel 1's 24-bit and 16-bit counters.
Guides on setting preset values and programming options for Channel 2's 24-bit and 16-bit counters.
Provides a step-by-step guide to programming the module, including writing presets, programming the module, and setting RUN mode.
Guides on selecting software bits in preset and setup words to enable functions and configure 24-bit counters.
Details selecting setup word bits and preset words to enable functions and modes for 16-bit counters.
Outlines the steps for programming the module, including writing presets and setting the program bit to enter Run Mode.
Offers basic troubleshooting suggestions for common module symptoms like no LEDs, incorrect counts, or communication issues.
To Next Page
