EasyManuals Logo

Siemens SIMATIC TI505 User Manual

Siemens SIMATIC TI505
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #92 background imageLoading...
Page #92 background image
Optional Configurations
5-18
High Speed Counter Encoder Module User Manual
5.9 16-Bit Counter Software Setup Options
After
you configure the hardware jumpers, select the associated bits in the
setup words to enable the functions and select the mode. There are two
setup words and two preset words associated with the 16-bit counters. In
the interest of simplicity
, only the parts of these words pertinent to the
16-bit counter are shown. Bits that are in the 1 state set the function; bits
that are 0 reset the function.
The module setup words have two modes: Run and Program. In Program
Mode, the definitions in T
able 5-10 apply; in Run mode, T
able 5-1
1 applies.
During Program mode, the counters are inhibited and the outputs are off.
After setting up the module in Program Mode, set the module to Run Mode
as described in Section 5.10.
T
able 5-9 shows the format of the preset words for Counters 2, 3, 5, and 6.
T
able 5-10 and Table 5-1
1 present the bit definitions for the setup words.
T
able 5-9
16-Bit Counter Pr
esets 3, 4, 7, and 8 (WY25, 26, 31, and 32)
Word MSByte LSByte
WY25,
26, 31, 32
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Channel
1, 16-Bit
Counter Pr
esets

Table of Contents

Other manuals for Siemens SIMATIC TI505

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC TI505 and is the answer not in the manual?

Siemens SIMATIC TI505 Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC TI505
CategoryControl Unit
LanguageEnglish

Related product manuals