Parameterizing the SITOP UPS1600
6.2 Switching off the UPS when the power fails by a user program
SITOP UPS1600 under STEP 7 V12
Getting Started,
37
2. Match the addresses of the following symbols with the selected I/O address areas of the
corresponding UPS1600 parameters:
– UPS_Buffer_mode
– UPS_Ready_for_buffering
– UPS_New_alarms_pending
– UPS_battery_charge_level
3. Save the project and load the parameters into the S7 IO controller.
When the power fails, the user program now switches off the UPS.
To Next Page
Loading...
