Siemens SITRANS S7-300 - Introduction to SmartLinx Configuration; Objective of the Guide; Required Equipment List; Disclaimer of Information Accuracy

Configuring a SmartLinx ready device with a PROFIBUS DP card in a S7-300 or S7-400 PLC
4 Application examples, 08\2020, AG060425
1 Introduction
1
1.1 Objective
The objective of this application guide is to help the user become familiar with the steps
required to configure a SmartLinx device in Step 7.
1.2 Equipment
Equipment
Article No.
SITRANS instrument
.gsd file
SIMATIC STEP 7 ver. 5.2 (SP. 1)
MPI/PROFIBUS Interface to PLC
Terminal screwdriver
PC or Laptop
1.3 Disclaimer
Note
While every effort is made to verify the following information, no warranty of accuracy or
usability is expressed or implied.