Siemens S7-300 Series - User Manual

Copyright 2004 by Siemens AG
A5E00201782-03
Product Information on the Manual
Edition 12.2004
w S7-300 Programmable Controller; Module Specifications, as of Edition 02/2004
(A5E00105505)
w ET 200M Distributed I/O Device Signal Modules for Process Automation,
as of Edition 10/2004 (A5E00085262)
w S7-300, ET 200M Programmable Controller, Modules with Intrinsically-Safe
Signals, as of Edition 08/2003 (A5E00172008)
Introduction
Parameterizable signal modules of the S7-300 product family mentioned in this
product information document can be reparameterized online using
STEP7 HWCONFIG in RUN mode of the CPU.
In other words, the module parameters can be changed without switching the CPU
to STOP mode or affecting other modules.
The following prerequisites must be met in order to use this function:
• STEP7 as of Version 5.2
• Distributed use of the S7-300 modules described in the S7-400 programmable
controller (CPUs as of V3.1 or CP 443-5 extended as of V5.0).
• Use of the ET 200M with the IM 153-2 as of 6ES7153-2BA00-0XB0 or
6ES7153-2BB00-0XB0
• Use of the IM 157 as of 6ES7157-0AA82-0XA00
You will find a detailed description of the prerequisites and principles of operation in
the manual Modifying the System during Operation via CiR
(visit http://www.siemens.com/automation/service&support and enter
the entry ID: 14044916).

Siemens S7-300 Series Specifications

General

Mounting	DIN rail mounting
Protection Class	IP20
CPU Types	Various (e.g., CPU 312, CPU 314, CPU 315-2 DP, CPU 317-2 DP, etc.)
Memory	Depends on CPU model (e.g., 64 KB to 8 MB)
Digital Inputs (DI)	Depends on module (e.g., 8, 16, 32, or 64 channels)
Digital Outputs (DO)	Depends on module (e.g., 8, 16, 32, or 64 channels)
Analog Inputs (AI)	Depends on module (e.g., 2, 4, 8, or 16 channels)
Analog Outputs (AO)	Depends on module (e.g., 2, 4, 8, or 16 channels)
Digital I/O	Combination of DI and DO modules
Analog I/O	Combination of AI and AO modules
Communication Interfaces	MPI, PROFIBUS DP, Ethernet
Programming Languages	LAD, FBD, STL, SCL, GRAPH
Power Supply	24V DC
Supply Voltage	24 V DC
Operating Temperature	0°C to +60°C (horizontal mounting)
Relative Humidity	10% to 95% (non-condensing)