The lter is no longer effective when the
Change filter! display appears, or at
the latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Replacement lters can be obtained from
retailers or from customer service (see
“Accessories”). If no new lter is used, turn
the
Filter setting to No / Old.
Note: You can use the lter indicator to
mark the month in which you inserted the
lter. You can also mark the month in which
you will need to replace the lter next (at
the latest after two months).
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
lter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.
Menu settings
You can adapt the appliance to your
individual needs in the menu settings.
1. Hold the e off / j button (12) down for at
least 3 seconds.
2. Press the
e off / j button (12) repeatedly
until the required menu item appears in
the display.
3. Select the required setting with the
upper rotary knob (14).
4. Conrm by pressing the start button
(10).
To leave the menu without making any
changes, turn the rotary selector to
Exit and
press the start button (10).
You can set the following:
Shut off
Here you can set the time span after which
the appliance automatically switches off
following the last drink preparation. A time
between 15 minutes and 4 hours can
be set. To save power you can specify a
shorter period.
Filter
Here you can set whether a water lter is
being used. If a water lter is not being
used, turn the setting to No / Old. If a
water lter is being used, turn the setting to
Activate filter. New water lters have to
be rinsed before use (see “Water lter”).
Start Calc’nClean
The service programmes (Calc’nClean /
descaling / cleaning) can be selected
manually here. Press the start button (10)
and run the selected programme (see
“Service Programmes”).
Temp.
The brewing temperature (high / middle /
low) can be set here.
Language
The display language can be set here.
Water hardness
The water hardness setting can be adjusted
on this appliance. It is important to set
the water hardness correctly, so that the
appliance indicates accurately when the
descaling programme should be run. The
factory setting for the water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier.
To Next Page
Loading...
