Siemens TE 502 SERIES - Preparing Milk Froth; Frothing Milk for Beverages; Maintenance and Daily Cleaning; General Cleaning Procedures

11
en
Preparing milk froth
A
Risk of burns
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
Tip: You can foam the milk rst and then
dispense coffee, or foam the milk separately
and pour it onto the coffee.
The appliance must be ready for use with
the cleaned milk frother attached.
1. Press the h button (11).
The h button (11) ashes and the
appliance now heats up for approx. 20
seconds. The display then shows Pull
milk frother.
2. Immerse the milk frother so that it
reaches the bottom of a cup or glass
that is one-third lled with milk.
3. Pull the milk frother (6) to open it.
A
Risk of scalding
Splashes of milk can scald. Carefully open
the milk frother (6). Do not touch the outlet
or aim it at anyone. The milk frother (6)
gets very hot. Hold the milk frother (6) by
the plastic part only. After use, allow to cool
down rst before touching. Use this appli-
ance only after the milk frother (6) has been
fully assembled and installed.
4. Close milk frother (6) by pushing it in.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difcult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the Rinse milk
system programme.
Maintenance and
daily cleaning
A
Risk of electric shock
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
soft, damp cloth.
● Do not use abrasive cloths or cleaning
agents.
● Always remove any limescale, coffee, milk
or descaling uid residue immediately.
Such residue can cause corrosion.
● New sponge cloths may contain salts.
Salts can cause rust lm on stainless
steel and must therefore be washed out
thoroughly before use.
● Pull the drip tray (8c) with the coffee
grounds container (8b) forward and out.
Remove the panel (8a) and the grate
(8d). Empty and clean the drip tray and
coffee grounds container.
● Remove drawer (4) and clean.