Siemens te501 series User Manual

8
en
3� Turn the rotary
knob (13) to position
4� Press and hold buttons
B (11) and
A (12) simultaneously for at least
5 seconds� Either “off” or “on”
lights up�
5� Press the start button (10) to select “on”�
6� Press and hold the start button (10) for
at least 5 seconds to conrm. All of the
LEDs light up briey.
7� LED D ashes and LED F lights up�
8� Place a container with a capacity
of 0�5 litres under the milk frother
outlet (6)�
9� Pull out the milk frother (6) to open it�
LED F ashes.
10� Water will now ow through the lter and
rinse it�
11� When LED
F lights up constantly,
press in the milk frother (6) to close it�
12� Empty the container�
The appliance is ready to use again�
Information: Rinsing the lter simultaneously
activates the setting for the change lter
display (= LED D ashes).
The lter is no longer effective when the
change lter display appears, or at the
latest after two months� It needs to be
replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance)� Replacement
lters can be obtained from retailers or from
customer service (see “Accessories”)� If no
new lter is inserted, change the setting for
the lter (see “Water hardness”).
Information: You can use the lter indicator
to mark the month in which you inserted the
lter. You can also mark the month in which
you will need to replace the lter next
(at the latest after two months)�
Information: If the appliance has not been
used for a prolonged period (for example,
when you are on vacation), the existing lter
should be rinsed before the appliance is
used again� To do so, dispense a cup of hot
water and pour it away�
Settings
You can customize the settings on the
appliance�
You can make the following adjustments:
Water hardness
The water hardness setting can be adjusted
on this appliance� It is important to set
the water hardness correctly so that the
appliance can accurately indicate when it is
time to run the descale process� The factory
setting for the water hardness is 4� You can
establish the water hardness either by using
the test strip provided or by asking your local
water provider�
Dip the test strip in the water briey, shake
it gently and check the result after one
minute�
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
If you wish to change the default degree of
water hardness, or if you have inserted a
water lter, proceed as follows:

Siemens te501 series Specifications

General

Brand	Siemens
Model	te501 series
Category	Coffee Maker
Language	English