Siemens te501 series - Cleaning the Milk Frother

13
en
Cleaning the milk frother
The milk frother (6) must be cleaned after
each use in order to remove residues�
Important: Let the milk frother cool down
before you remove it�
Dismantle the milk frother for cleaning:
1� To remove, take hold of the metal sleeve
and pull it downwards and off�
2� Twist the steam nozzle (6d) anticlock-
wise and remove it�
1
2
6d
3� Remove the frothing tube (6c)�
6c
4� Clean the individual parts with a
detergent solution and a soft brush�
If necessary, soak in a warm detergent
solution� Clean the air hole (6e)
thoroughly�
6e
5� Rinse all parts with clean water and dry�
6� Fit the steam nozzle (6d) and frothing
tube (6c) back into the metal sleeve�
1 2
6d6c
7� Twist the steam nozzle clockwise until
the marks are aligned�
8� Attach the milk frother to the steam
valve� Check that the red mark on the
steam valve is covered�
A
Risk of scalding!
Only use the appliance when the milk
frother (6) is completely assembled and
tted.