Siemens te501 series - Page 23

19
en
Problem Cause Remedy
LED
D ashes.
The water tank is not
correctly installed or the
lter is worn.
Correctly install the water tank�
If the LED continues to ash,
install a new lter and rinse, see
chapter “Filter”�
Carbonated water in the
water tank�
Fill the water tank with fresh tap
water�
The coffee grounds are
not compact and are too
wet�
The grind setting is too
ne or too coarse, or not
enough ground coffee has
been used�
Adjust the grinding unit to a
coarser or ner setting, or use
2 level measuring spoons of
ground coffee�
LED
I ashes.
Brewing unit (5) is soiled� Clean the brewing unit (5)�
Too much pre-ground
coffee in the
brewing unit (5)�
Clean the brewing unit (5) Put in
no more than 2 level measuring
spoons of ground coffee�
The brewing unit
mechanism is stiff�
Remove and clean the brewing
unit, see “Maintenance and daily
cleaning”�
Brewing unit (5) is missing
or has not been detected�
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance again�
Coffee or milk froth quality
varies widely�
Build-up of limescale in the
appliance�
Descale the appliance as
described in the instructions�
Water dripped onto the
inner oor of the appli-
ance when the drip tray
(8) was removed�
Drip tray (8) removed too
soon�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray (8)�
The default settings have
been changed and need
to be reset�
Some settings have been
made that are no longer
required�
Press the power on/off button O / I
(9) to switch off the appliance�
Press and hold the service button
(12) and the steam button (11)
and press the power on/off button
O / I (9) to switch on the appliance�
Then press the start button (10) to
conrm. The default settings are
reset�
LEDs
ash.
The appliance has a fault� Please contact the hotline�
LEDs
ash.
Incorrect voltage� Operate the appliance at
220 V-240 V only�
LEDs
ash.
The ambient temperature is
too cold�
Operate the appliance at
temperatures > 5° C�
If you are unable to solve the problem, please call the hotline.
You will nd the telephone numbers at the back of these instructions.