NLSet up and connect
Place of installation Requirements
1.Pull the hoses out of the holders.
Floor with wooden
beams
Place the device
count on a
resistant
wooden plate (thick
too minimal
30mm) which
screwed firmly
to the floor.
Kitchenette The device al-
borrow under one
continuous work
place sheet,
that with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
2.Loosen and remove all bolts of the 4
transport protection devices with
an open-end wrench SW13
.
On a wall No mains connection
cable and none
snakes in between
wall and equipment
wedge in.
4.4 Remove transport
protection devices
3.Remove the mains connection cable from
the holder.
The device is secured for transport
with transport locks on the back of the
device.
Remark:Keep the bolts of the
transport protection devices and the
sleeves for later transport.
ā
"Install transport protection", page
49
14
To Next Page
Loading...
