Siemens WM14N277NL - Essentials of the Operation; Switching on the Device; Set Program; Adjusting Program Settings

ServiceNL
¡No too long stored and strong in-
using thickened products. ¡do not
use solvent-containing
the, corrosive or gaseous agents
¡Use dyes in moderation,
salt can affect stainless steel
¡no bleach in the appliance
use ready
13.4 Filling the drum with
laundry
Remark:To avoid creasing, please
observe the maximum load of the
programs.
→ "Programs", page 25
Requirements
¡The laundry is prepared and
sorted.
→ "Laundry", page 28
¡The drum is empty.
B1operation 3 The Operation in es-
sentie
Service
1.Open the door.
13.1 Switching on the device
2.Place the laundry in the drum.
Required:The device is set up and
connected correctly.
→ "Setup and connection",
page 13
3.Close the door.
Make sure that no small items of
laundry are caught in the door.
▶ Set the program selector to a
programme.
13.5 Insert dosing aid for liquid
detergent
13.2 Set program
When you order the dosing aid as an
accessory, you must fit the dosing aid.
1.Pull out the detergent drawer.
1.Turn the program selector and set
it to the desired programme.
→ "Programs", page 25
2.Press the insert down and remove
the detergent drawer.
2.Adjust the program settings if
desired.
→ "Adjust program settings", page
29
13.3 Adjust program settings
Required:A program is set.
→ "Set program", page 29
▶ Adjust the program settings.
a 24 → "Keys", page
Remark:The progr
genes are not saved
perm program
amma settings
anent for it
and.
29