Siemens WM14N277NL - Change Activated Program End Time; Adding Laundry; Progr. Cancel; Resuming Program at Rinse Hold

ServiceNL
aThe display shows the program
duration or the program end time.
aAfter program end it shows
display: End.
13.11 Progr. Cancel
1.OnStart / Refillto press.
2.Open the door.
At high temperature and high
water level, the door of the
appliance remains locked for safety
reasons.
– At a high temperature, start the
programmeTo rinse.
– Start the program at a high water
levelCentrifuge or select a
suitable program for draining.
→ "Programs", page 25
13.9 Change activated
program end time
You can change the set and changed
program end time several times
before you start the programme.
Requirements
¡The program is set.
→ "Set program", page 29
¡The program end time is set
and activated.
→ "Buttons", page 24
3.Remove the laundry.
→ "Remove laundry",
page 31
1.OnStart / Refillto press.
13.12 Resume program at
rinse hold
The activated program end time is
paused.
2.OnReady in press to it
display the desired program end
time is shown.
Requirements
¡The rinse hold is activated.
→ "Buttons", page 24
¡The last rinse of the
set program has ended and the
laundry is in the rinse water.
3.OnStart / Refillto press.
The changed program end time is
activated.
1.The programCentrifugeor set a
program for draining.
→ "Programs", page 25
13.10 Add laundry
After the program has started, you
can remove or add the laundry
depending on the program status.
1.OnStart / Refillto press.
2.OnStart / Refillto press.
13.13 Remove laundry
The device pauses.
1.Open the door.
Remark:If you want to add laundry,
follow the instructions on the
display.
→ "Display", page 23
2.Remove the laundry from the
drum.
13.14 Switch off the device
2.Open the door.
3.Add or remove the laundry.
4.Close the door.
5.OnStart / Refillto press.
1.The program selector onOutto make.
31