NLSet up and connect
Siphon The connection position
tie with one
hose clamp
(24-40 mm) Bore
gene.
2.To adjust the device, turn the device
feet. Check the horizontal
adjustment of the device with a
spirit level.
Washbasin The water
feeding hose with
a bend
→
Page 28
fix and bor-
gene.
plastic stand
pipe with rubber
run muff or one
floor drain
The water
feeding hose with
a bend
→
Page 28
fix and bor-
gene.
All device feet must be firmly on the
floor.
3.Tighten the counter nuts against
the housing hand-tight with a
SW17 open-end wrench.
4.6 Adjusting the device
To reduce noise and vibrations and
avoid the device walking, set the
device horizontally.
1.Loosen the lock nuts with a SW17
open-end wrench.
Hold the appliance foot firmly
and do not adjust the height.
4.7 Connecting the device
electrically
Remark:Your domestic electrical
installation for this appliance must
comply with local legal and safety
regulations and must include an
earth leakage circuit breaker.
16
To Next Page
Loading...
