TroubleshootingNL
Malfunction Cause and Troubleshooting
Centrifuge result is
not satisfied-
ity. The laundry is too
wet / too damp.
The imbalance detection system has stopped the spin
cycle due to uneven distribution of the laundry.
▶ Redistribute the laundry in the drum.
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
▶ Launch the programCentrifuge.
Imbalance control system compensates for
imbalance by reduced spin speed.
▶ Redistribute the laundry in the drum.
Remark:If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is distributed better during the spin cycle.
▶ Launch the programCentrifuge.
Leftover detergent
the damp laundry.
Detergents may contain water-insoluble substances
that settle on the laundry.
▶ Launch the programTo rinse.
Detergent residues
the dry laundry.
Detergents may contain water-insoluble substances
that settle on the laundry.
▶ Brush the laundry after washing and drying.
At the water supply
feed hose is leaking water.
The water supply hose is not correctly / firmly connected.
1.Connect the water supply hose correctly.
→
"Connect the water supply hose", page 15
2.Tighten the coupling properly.
Water is leaking from
the water drain hose.
Water drain hose is damaged.
▶ Replace the damaged water drain hose.
Water drain hose is not connected correctly.
▶ Connect the water drain hose correctly.
→
"Water outlet connection types", page 15
Odor formation has
occurred in the appliance
Pine tree.
Humidity and detergent residue can stimulate
bacterial growth.
▶
→
"Clean the drum", page 34
▶ If you are not using the appliance, leave the door and
detergent drawer open so that the residual water can
dry up.
47
To Next Page
Loading...
