Siemens WM16XKH2ES - Page 47

Troubleshooting en
47
Fault Cause and troubleshooting
"E:35 / -10" The appliance is leaking.
▶
Turn off the water tap.
▶
Call the after-sales service.
→"Customer Service", Page57
The detergent drawer has not been pushed in as far
as it can go.
▶
Push the detergent drawer in as far as it will go.
The pump unit is not inserted.
1. Insert the pump unit into the detergent drawer.
→"Cleaning the detergent drawer", Page40
2. Push the detergent drawer in as far as it will go.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶
If intelligent dosing is activated, reduce the basic
dosage →Page35.
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
lights up. The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page32
Water level is too high.
▶
Select a suitable programme for draining.
→"Programmes", Page26
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press inicio/pausa+carga to start the programme.
flashes. Door is not closed.
1. Close the door.
2. Press inicio/pausa+carga to start the programme.
All other error codes. Malfunction
▶
Call the after-sales service.
→"Customer Service", Page57