Siemens WU12UT61ES - Page 41

Troubleshooting en
41
Fault Cause and troubleshooting
"E:92 /- 01" The water inlet hose is kinked or jammed.
▶ Ensure that the water inlet hose is not kinked or
jammed.
Water level measurement system is defective.
Note:With the error message, the appliance starts a
draining process.
1. First wait approx. 5 minutes until the drain process
ends.
2. To reset the error message, switch the appliance
off.
3. Switch the appliance back on.
4. If the error message is displayed again, call cus-
tomer service.
→"Customer Service", Page50
Voltage under-usage
symbol (double point).
The automatic voltage control system detects an un-
authorised voltage under-usage.
▶ No remedial action possible.
Note:If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
flashes. Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page32
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page24
flashes. Door is not closed.
1. Close the door.
2. Press inicio/pausa+carga to start the programme.
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press inicio/pausa+carga to start the programme.