Siemens WU14UT60HK - Resuming from Rinse Hold; Unloading the Laundry; Switching off the Appliance; Childproof Lock

en Childproof lock
32
– If the water level is high, start
the Spin programme or select
a suitable programme for drain-
ing.
→"Programmes", Page24
3. Remove the laundry.
→"Unloading the laundry",
Page32
13.13 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→"Buttons", Page23
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the Spin programme or a
programme for draining the water.
→"Programmes", Page24
2. Press ⁠Start/Reload.
13.14 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
13.15 Switching off the appli-
ance
1. Turn the programme selector to
Off .
2. Turn off the tap.
3. Wipe the rubber gasket dry and re-
move any foreign objects.
4. Leave the appliance door and de-
tergent drawer open so that resid-
ual water can evaporate.
Childproof lock
14 Childproof lock
Childproof lock
Secure your appliance against being
operated unintentionally using the
controls.
14.1 Activating the childproof
lock
▶ Press and hold the two ⁠3 sec.
buttons for approx. 3seconds.
a The display shows .
a The control elements are locked.
a The childproof lock remains active
even after the appliance has been
switched off and in the event of a
power cut.
14.2 Deactivating the child-
proof lock
Requirement:To deactivate the
childproof lock, the appliance must
be switched on.
▶ Press and hold the two ⁠3 sec.
buttons for approx. 3seconds.
a goes out in the display.