Siemens WU14UT60HK - Changing Basic Settings; Programme Counter; Calling up the Programme Counter; Cleaning and Servicing

en Programme counter
34
15.2 Changing the basic set-
tings
1. Set the programme selector to po-
sition 1.
2. Press ⁠Start/Reloadand, at the
same time, turn the programme
selector to position2.
a The display shows the current
value.
3. Set the programme selector to the
required position.
→"Overview of the basic settings",
Page33
4. To change the value, press ⁠Fin-
ish in.
5. To save the changes, switch off
the appliance.
Programme counter
16 Programme counter
Programme counter
The program counter displays the
number of finished programmes.
16.1 Calling up the pro-
gramme counter
1. Set the programme to position1.
2. Press ⁠Start/Reload and set the
programme to position 2 at the
same time.
3. Set the programme to position5.
Cleaning and servicing
17 Cleaning and servi-
cing
Cleaning and servicing
To keep your appliance working effi-
ciently for a long time, it is important
to clean and maintain it carefully.
17.1 Cleaning the drum
CAUTION
Risk of injury!
Permanently washing at low temper-
atures and a lack of ventilation for
the appliance may damage the drum
and cause injury.
▶ Regularly run a programme for
cleaning the drum or wash at tem-
peratures of at least 60°C.
▶ Leave the appliance to dry after
every operation with the door
open, and leave the detergent
drawer to dry.
▶ Run the Drum Clean pro-
gramme without laundry but with
washing powder that contains oxy-
gen bleach or a a cleaning agent
for caring for the inside of the ap-
pliance.
→"Accessories", Page28
17.2 Cleaning the detergent
drawer
1. Pull out the detergent drawer.