Basic operation en
31
13.8 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page29
▶ Press Start/Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.9 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→"Setting a programme", Page29
¡ The programme end time is set
and activated.
→"Buttons", Page23
1. Press Start/Reload.
The activated programme end time
is paused.
2. Press Finish in until the display
shows the required programme
end time.
3. Press Start/Reload.
The changed programme end time
is activated.
13.10 Soaking laundry
Note:No additional detergent is re-
quired for soaking. The appliance
uses the filled detergent for soaking
and washing.
Requirements
¡ The laundry is placed in the appli-
ance.
→"Loading laundry", Page29
¡ A programme has started.
→"Starting the programme",
Page31
1. Press Start/Reload approx.
10minutes after the programme
start.
The programme pauses and the
laundry can soak.
2. Press Start/Reload after the re-
quired soaking time.
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press Start/Reload.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page21
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press Start/Reload.
13.12 Cancelling the pro-
gramme
1. Press Start/Reload.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.