A5E32299685 XRS-5 Series Transducers – QUICK START MANUAL Page EN-7
mmmmm
English
Mounting
• Mount the transducer so that it is above the maximum material level by more than
the blanking value for accurate results. Refer to the associated transceiver manual
for information on setting the blanking value.
• The transducer must be mounted so that the axis of transmission is perpendicular to
the liquid’s surface.
• Do not over tighten mounting. Hand tightening of the mounting hardware is
sufficient.
• Consider the optional temperature sensor when mounting the transducer.
Suspended Conduit Bracket
Flexible conduit transducer should not be
subjected to wind, vibration or jarring.
Submersible Plywood
Submersible transducer, used in
applications where flooding is possible.
Plywood mounting provides excellent
isolation, but must be rigid enough to avoid
flexing if subjected to loading.
rigid metal
conduit
coupling
transducer
steel channel
coupling
transducer
flexible conduit
rigid metal
conduit
coupling
submergence
shield
To Next Page
Loading...
