24
HyperScan MODE
While the rangenders support single button push ranging operation, it is highly recommended that
you push and hold the RANGE button down to activate HyperScan mode. This mode allows you to
scan targets at 4X/second which signicantly improves ranging performance at extreme distances.
As the ranging distances are updated very quickly in HyperScan mode, once you release the RANGE
button the last acquired distance will be displayed. When ranging distant targets in HyperScan mode,
the display may update between no result and a distant range. By using RangeLock technology the
rangender will report the last range result when the RANGE button is released.
CHANGING MODES OF OPERATION
The rangender ships with the most common modes already congured. However, you can access and
change the following features:
• Line of Sight (LOS), Angle Modied Range (AMR), AB Ultralite (BDX-U) or AB External (BDX-X)
• First, Best, Last Target, Extended Range (XR) or Fog
• Display Brightness (AUTO + 3 Low, 3 Medium and 3 High)
• Units of Measure (Y or M)
• Ballistic Group Selection (Centerre Groups 1-6, Muzzleloader Group 7 and Crossbow Group 8).
• Initiate QuickBOND (On or O)
To Next Page
Loading...
Need help?
General
