22
FREQUENTLY ASKED QUESTIONS (FAQ):
Q: I am pressing the RANGE button and nothing happens?
A: Check to make sure you have a fresh CR2 battery installed. If the battery is new, try loosening and
tightening the battery cap until the cap is snug. If this doesn’t fix the problem you may have switched the
KILO2000 into one of the low brightness settings for the OLED display. Go into a dark room and press the
RANGE button. In this case, if the display becomes barely visible you need to go into programming mode
and adjust the brightness to a medium or high setting, or put the display in AUTO adjust mode.
Q: Information on the display is disappearing, is this normal?
A: Yes. The KILO2000 display was optimized to only present the most important information while in
use. Upon initial wake up, all your settings are visible such as the battery indicator, Line of Sight (LOS)
or Angle Modified Range (AMR), Last or Best target mode and unit of measure. After the first range
is acquired or in Scan mode, after about 2 seconds, only the aiming circle and range information is
displayed.
Q: Why does the display switch back and forth in numbers sometimes? Sometimes the
number is negative?
A: When in Line of Sight mode (LOS), the KILO2000 displays the distance to the target independent of
angle of incline or decline. In addition to displaying the LOS range, the KILO2000 will then toggle back and
forth between the LOS range and the angle.
To Next Page
Loading...
Need help?
General
