All of the parts on the plan are identified by a number or a letter.
Parts identified by a number are laser cut parts.
Parts identified by a letter are stripwood pieces that you cut and fit on assembly.
The slight discoloration of the edges of the laser cut parts may be removed by lightly sanding them with 400 grit
sandpaper.
The assembly of this model begins by building the fuselage side frames and then parts are added or assembled in
COMPLETE KIT PARTS LIST
1 Plan Sheet #1 1 Plan Sheet #2 1 Decal Sheet
3 Yellow Tissue 1 1/16"x12" Music Wire 1 Tail Wheel Assembly
1 15" Thread 2 1/ 8"x4" Solder 3 3 1/4"x6" Window Material
8 1/16"sq.x18" Balsa Strip 12 3/32"sq.x18" Balsa Strip 2 1/8"sq.x18" Balsa Strip
1 3/16"x1 3/4" Dowel 1 Instruction Manual 1 9" Plastic Propeller
1 Propeller Shaft 2 Brass Thrust Washers 1 Plastic Propeller Bearing
2 1/4"x1/2" Black Rubber Tube 2 1/16"x1/16" Plastic Tube 1 6" Copper Wire
1 3/16"x60" Rubber Strip 15 Laser Cut Sheets
Tools and Building Supplies
You will need the following items to assemble this model. You must read and follow all of the manufactures
instructions provided with these items!
-Glue CA, White Glue, Sigment or Ambroid all work well.
-Cutting Tools A single edge razor blade can be used for all of the cutting.
-Clear Dope, Thinner & paint brush -200, 320 and 400 sandpaper
-Straight Pins -Wax Paper
-Needle nose pliers -Crayon or Candle
-1/4" Drill Bit -Building Board
To Next Page
Need help?
General