Sigineer Power MS6048D User Manual

www.sigineer.com
25
Operation mode
Description
LCD display
Standby mode / Power saving
mode
Note: *Standby mode: The
inverter is not turned on yet
but at this time, the inverter
can charge battery without
AC output.
*Power saving mode: If
enabled, the output of inverter
will be off when connected
load is two low or not
detected.
No output is
supplied by the
unit but it still can
charge batteries.
Charging by utility and PV
energy.
Charging by utility
Charging by PV energy
No charging
Fault mode
Note:
*Fault mode: Errors are
caused by inside circuit error
or external reasons such as
over temperature, output short
circuited and so on.
PV energy and
utility can charge
batteries.
Charging by utility and PV
energy
Charging by utility
Charging by PV energy
No charging
Line Mode
The unit will
provide output
power from the
mains. It can also
charge the battery
at line mode.
Charging by PV energy
Charging by utility
No battery connected
Battery Mode
The unit will
provide output
power from
battery and PV
power.
Power from battery and PV energy

Sigineer Power MS6048D Specifications

General

Brand	Sigineer Power
Model	MS6048D
Category	Inverter
Language	English