Sigma BM40 - EXTRAORDINARY MAINTENANCE; Greasing Points; Power Cable Replacement; Cleaning Instructions

Instruction manual BMC-40 -VVM-
14 of 19
EXTRAORDINARY MAINTENANCE:
Should a power
cable be
damaged, replace
it with a H07RN/F
cable with a 3x1.5
mm2 section.
Cleaning: the mixer is not jet-
proof. Do not wash it with
running water. Clean it with a
moist cloth and neutral
detergents, such as
degreasing agents based on
Castile soap
,
A
To carry out interventions not specially mentioned in the manual, refer
to personnel authorised by SIGMA SrL. To replace the motor or the
circuit boards, or else if the mixer falls, contact our assistance service
for an intervention on site or else an overhaul at the factory
grease
nipples
Grease
manually
Grease
manually