21
For extended storage, choose a cool dry place, preferably
with good ventilation. It is recommended that the flash be
charged and fired several times a month, to maintain proper
capacitor functioning.
Do not fire the flash while covering the Flash Head with cloths
or clothes as it could cause fire.
ABOUT THE BATTERY
This flash unit uses four “AA” type Ni-MH rechargeable batteries or
alkaline dry cell batteries.
To assure proper electrical contact, clean the battery terminals
before installing the batteries.
To prevent battery explosion, leakage or overheating, use four
new AA batteries of the same type and brand. Do not mix the type
or new and used batteries.
Do not disassemble or short-circuit the batteries, or expose them
to fire or water; they may explode. Do not recharge the batteries
other than Ni-MH rechargeable batteries.
When the flash will not be used for an extended period of time,
remove the batteries from the flash to avoid the possibility of
damage from leakage.
As with any flash, it is recommended you carry spare batteries
when on a long trip or when photographing outdoors in cold
weather.
Do not use Lithium AA/R6 Batteries. It may cause your equipment
to malfunction.
Please follow all guidelines, rules and regulations of your
community regarding the disposal of batteries.
DESCRIPTION OF THE PARTS
(
P.2
)
Flash Head
Wireless Signal Receiving
Window
BEEP Switch
AF Assist Light
Battery Cover
Shoe
LCD Panel
Backlight Switch
Power Switch
Ready Light /TEST Button
Button
Selector
Shoe Lock Lever
Dial
Sync. Terminal
Catch Light Panel
Wide Panel
SELECTOR (13)
In this instruction manual, each position of selector is shown as
/ / / .
(Up button)
(Right button)
(Down button)
The buttons are used as follows: To operate Up and Down
buttons: . To operate Left and Right buttons: .
COMPATIBLE CAMERAS
This flash is compatible with the following cameras.
E-TTL II / E-TTL auto flash system EOS digital camera
To Next Page
Loading...
