Sigma PC 26.14 - Display, button functions, and navigation; Waking up the device; Display layout

4 5
1.2 Button functions
The PC 26.14 has five buttons:
TOGGLE/-, TOGGLE/+, STOP, START, and ENTER
STOP button:
This button takes you back a level
within the menu structure. In training
mode, stop the training session by
pressing this button.
Resetting training data without
saving: Press and hold the STOP
button.
TOGGLE/- and
TOGGLE/+ buttons:
TOGGLE/+ enables you to navigate to the
right in the main menu; TOGGLE/- takes
you back again. If you are at a point at which
values can be configured, use TOGGLE/+
to set a higher value and TOGGLE/- to set
a lower value.
Activating/deactivating the light mode
Press the TOGGLE/- AND TOGGLE/+
buttons simultaneously. Pressing the
buttons simultaneously a second time
switches the display backlight off again.
The light stays on for approx. three seconds.
START button:
Press the START button to start
training.
Pressing the START button again
while training marks a lap.
If you have paused a training
session by pressing the STOP
button, you can restart the timer by
pressing the START button again.
Lap view:
Press and hold the START button.
Press the STOP button to exit
lap view.
ENTER button:
Use this button to access the main
menu and confirm the entries.
You can navigate in the submenu
of the applicable menu item and
access any further sub-items
available.
EN