SIGMATEK CCP 531 User Manual

C-DIAS PROCESSOR MODULE CCP 531
12.04.2017 Page 23
05
Watchdog
The program was interrupted through the
watchdog logic.
Possible Causes:
- User program interrupts blocked
over a longer period of time (STI
command forgotten)
- Programming error in a hardware
interrupt.
- INB, OUTB, INW, OUTW instruc-
tions used incorrectly.
- The processor is defect.
Solution:
- Correct programming error.
- Exchange CPU.
06
GENERAL
ERROR
General error
07
PROM DE-
FECT
An error has occurred while programming
the memory module.
Cause:
- The program memory module is
defect.
- The user program is too large.
- The program memory module is
missing.
Solution:
- Exchange the program memory
module
08
Reset
The CPU has received the reset signal
and is waiting for further instructions.
The user program is not processed.
09
WD DEFEKT
The hardware monitoring circuit (watch-
dog logic) is defect.
After power-up, the CPU checks the
watchdog logic function. If an error
occurs during this test, the CPU deliber-
ately enters an infinite loop from which no
further instructions are accepted.
Solution: Exchange CPU.
10
STOP
11
PROG BUSYS
12
PROGRAM
LENGTH
13
PROG END
The memory module was successfully
completed.
14
PROG MEMO
The CPU is currently programming the
memory module.

SIGMATEK CCP 531 Specifications

General

Brand	SIGMATEK
Model	CCP 531
Category	Control Unit
Language	English