SIGMATEK CCP 531 User Manual

C-DIAS PROCESSOR MODULE CCP 531
12.04.2017 Page 19
Shielding
The wiring for the CAN bus and Ethernet must be shielded. The low-ohm shielding is either
connected at the entry to the control cabinet or directly before the CCP 531 processor
module over a large surface (cable grommets, grounding clamps)!
Noise signals can therefore be prohibited from reaching the electronics and affecting the
function.
ESD Protection
Before any device is connected to or disconnected from the CCP 531, the potential with
ground should be equalized (by touching the control cabinet or earth terminal). Static elec-
tricity (from clothing, footwear) can therefore be reduced.
Working with and on the CCP 531
 Valid operating and safety guidelines for personal safety must always be observed.
 With installation /initial start-up / product maintenance, the relevant measures for ESD
protection must be taken.
(For example: the employees must ground themselves before they start working with and on the
product.
a

SIGMATEK CCP 531 Specifications

General

Brand	SIGMATEK
Model	CCP 531
Category	Control Unit
Language	English