Need help?Do you have a question about the SIGMATEK SCP 111 and is the answer not in the manual?
General| Product Type | Control Panel |
|---|---|
| Interfaces | Ethernet, USB, Serial |
| Power Supply | 24 VDC |
| Touchscreen | Yes |
| Protection Class | IP65 front |
| Ethernet Ports | 1 |
| USB Ports | 2 |
| Serial Ports | 1 x RS232/RS485 |
| Operating Temperature | 0 to 50 °C |
Explains dangers and safety symbols for risk prevention.
Lists warnings for electrical voltage, hot surfaces, and ESD-sensitive components.
Outlines requirements for technical documentation and acceptance of safety guidelines.
Defines qualified personnel and designated use for safety modules.
Lists relevant functional safety standards (EN/IEC 62061, EN ISO 13849).
States compliance with European directives like Machinery, EMC, and RoHS.
Specifies safety parameters and levels for ambient temperature ranges.
Details firmware version requirements for Safety Designer compatibility.
Lists interfaces, program interfaces, bus connection, and supply voltage.
Details module input supply and S-DIAS bus/safety supply output.
Covers article number, hardware version, standard, and approvals.
Specifies operating temperature, humidity, and installation altitude.
Explains the meaning of various LED indicators for module status.
Details connector types (USB, spring terminals) and their specifications.
Information about the label field, manufacturer, and compatible printer.
Explains start, command selection, end, and error sequences using the validation button.
Lists available commands, their mapping to system statuses, and LED indications.
Describes using SD cards for storing and loading safety projects.
Step-by-step guide to load configuration from an SD card to the Safety CPU.
System behavior and states during restart errors.
Common causes for failed configuration distribution.
General troubleshooting, SafetyDesigner debugging, and wiring error correction.
Lists supported cycle times below 1 ms (in µs).
Lists supported cycle times equal to or higher than 1 ms (in ms).
Mentions observing disposal guidelines for the product.
Identifies general hardware properties like ClassState, DeviceID, and version.
Details Safety States, Run States, and Service Modes of the module.
Covers error states, communication error cancellation, and validation button status.
Details FlexConNode communication, interfaces, and data size specifications.
Methods to fetch and get diagnostic states and information.
Manages log files and explains the importance of ClassState and SafetyState.
Details internal properties and methods for safe signal transmission between PLCs.
To Next Page
