SIGMATEK SCP 111 User Manual

S-DIAS SAFETY CPU MODULE SCP 111
04.11.2020 Page 29
6.4 Handling the microSD Card
An SD card can only be written on with the Safety Designer. A detailed description can be
found in the Safety System Handbook (Link: https://www.sigmatek-
automation.com/fileadmin/user_upload/downloads/Safety-Systemhandbuch-eng.pdf).
A Safety project, which was programmed with the SafetyDesigner, can be stored on an SD
card. The stored Safety project can then be loaded into an additional SCP Safety-CPU,
providing that the module's Flash memory is empty (cleared).
If the configuration on the SD card is different from that on the Safety CPU Flash, the system
switches to the error status (error message 87). The SD card cannot be inserted into the
Safety CPU during normal operation (Operational or temporary operational mode). If the SD
card is inserted during normal operation, the Safety CPU switches to the error status (error
message 88). However, an SD card can be removed during normal operation.

SIGMATEK SCP 111 Specifications

General

Brand	SIGMATEK
Model	SCP 111
Category	Control Unit
Language	English