SIGMATEK SCP 111 - Page 30

SCP 111 S-DIAS SAFETY CPU MODULE
Page 28 04.11.2020
Executed
command
Command function
Status after command
execution
QUIT_ERROR
A possible error is cancelled in the Safety CPU
and all safety modules required by the Safety
CPU and the error status is ended.
SW-RESET *)
CLR_CFG
The configuration in the Safety CPU is deleted.
After executing the command, the Safety CPU is
now in service mode.
Service mode
SET_VERIFIED
The configuration status is set to "verified".
Operational mode
*) A SW-RESET is performed. If the error still exists, the Safety CPU remains in the error mode. Otherwise, the
Safety CPU starts correctly.
General note: If a command was entered incorrectly, the Safety CPU initiates the error sequence (see above).
After ending the Error sequence, the command can be reentered.