Signal WS6980 - 3.4.2 TERR-SPECTRUM; 3.4.3 CABLE-SPECTRUM; 3.5 LOOP SEARCH; 3.6 OTHERS

12
3.4.2 TERR-SPECTRUM
• Full/Ch: Press red key to make all the frequency points we can see on the
window or to make some frequency points on it.
• Zoom: Press green key to enlarge showing the point you current select, and
press again
it will be back.
• Locked: Press orange key to lock all the current frequency points, and
remain unchanged unless you press again.
• Scan : When the frequency points have been locked, you can press blue key
to receive signal on a point.
3.4.3 CABLE-SPECTRUM
Please refer to 3.4.2.
3.5 LOOP SEARCH
We can see 8 TP or channels when we enter
into this interface, and press OK to edit.
There are 3 modes we can choose: DVB-S2,
DVB-T2 and DVB-C. Press the red key to change.
It will finish loop search after edition, then singal
strenth and quality of each TP or channel will
be displayed on the screen.
3.6 OTHERS
• Channel List
• EPG
• Satellite List
• Transponder List
• Motor Setting
• Angle Calculation
• Optical Power