9
2. Press the ‘Timer’ button on the unit’s control panel to activate the timer
function. The numbers ‘00’ will appear on the unit’s LCD screen to indicate this
function has been selected.
3. Once this function is in operation, repeatedly press the Timer button again
to select the desired duration for the timer, between 1 and 24 hours. The
corresponding number will appear on the unit’s LCD screen to indicate each
length of time has been selected.
NOTE: The timer length will increase by increments of 1.
NOTE: The timer operates in ascending order only. To set a length of time shorter
than the one currently selected, repeatedly press the Timer button until the timer
completes a full cycle, then start the process over from the beginning. Alternatively,
unplug the unit from the mains or press the Power button to reset it, then press the
Timer button again to re-start the process.
NOTE: Press the Timer key for 5 seconds to view the current room temperature.
FULL WATER TANK
When the tank is full, the corresponding symbol on the unit’s control panel will
illuminate, and the unit will switch off automatically. When this happens, turn off the
dehumidifier and empty the water tank.
To empty the water tank:
1. Pull out the rubber plug on the water displacement hole at the back of the unit.
2. Attach one end of the included rubber hose to the exposed hole.
3. Empty the water through the hole.
4. Put the rubber plug back into position, making sure it is secure.
5. Turn the unit back on.
6. The unit should now operate normally.
To Next Page
Loading...
Need help?
General
