Signode GRIPPACK - INCONSISTENT TOOL OPERATION

TROUBLESHOOTING GUIDES
20
0
Tool operates slow.
Operate Tool.
Does
tool make unusual
sounds?
YES
Inspect the gear
housing for worn
parts, proper
lubrication and
smooth operation.
Replace worn parts
and lubricate tool if
needed.
NO
Does
the tool
hesitate during the
strap tension?
YES
Contact
authorized
Signode repair
center.
Operate Tool.
Does
tool function?
YES NO
Contact
authorized
Signode repair
center .
INSPECT THAT
PROPER STRAP
AND
SEALS ARE BEING USED.
INSERT A FULLY CHARGED BATTERY
Cycles per battery charge decreases.
Press TEST button on
battery . Does battery pass?
YES
NO
Battery possibly
faulty or old .
Replace
battery.
Operate Tool.
Does
tool function?
YES NO
Contact
authorized
Signode repair
center.
Low strap tension.
Inspect the feedwheel
operating condition .
Does
the feedwheel appear
to be packed with debris?
NO
Does
the feedwheel
appear to be worn or is
the feedwheel milling on
the strapping.
YES
Replace parts as needed.
Feedwheel (423398)
YES
Clean the feedwheel
surface using a small wire
brush. Surface should
appear clean and sharp .
Operate Tool.
Does
tool function?
YES
NO
Inspect feedwheel to roller
clearance. Adjust gap
clearance as required per
maintenance instructions.
Operate Tool.
Does
tool function?
YES NO
Contact
authorized
Signode repair
center.