SIIG SuperSpeed USB 4-Port Hub - Complete Installation; Connect USB 3.0 Cable (Type-A to PC); Verify Successful Installation; Check Device Manager

4
3. Plug the Type-A connector of the included USB 3.0
cable into an available USB port (USB 3.0
recommended), and the driver will install
automatically.
4. The SuperSpeed USB 4-Port Hub is ready for use.
To Verify Successful Installation
1. Check in Device Manager to verify installation.
For Windows 7: Right click Computer, click Manage,
click Device Manager.
For Windows Vista: Right click Computer, click
Manage, click Continue, click Device Manager.
For Windows XP / Server 2003: Right click My
Computer, click Manage, click Device Manager.
For Windows Server 2008: Right click Computer,
click Manage, double click Diagnostics, click Device
Manager.
2. Double click Universal Serial Bus controllers.
For Windows 7 / Vista / XP
With SuperSpeed USB (USB 3.0) host adapter: NEC
Electronics USB Hub should be listed two times.
With Hi-Speed USB (USB 2.0) host adapter: Generic
USB Hub should be listed.
For Windows Server 2003 / 2008: Generic USB Hub
should be listed.