Silencer 65SL - Start Feature D Programming

IM_FULL_65SL_REV-A 16
START FEATURE “D” PROGRAMMING
Turn the Ignition ‘switch “ON/OFF” 3 times and stay in the “OFF” position.
Push the Valet switch 6 times (holding in on the 6
th
push) until one long chirp is heard and then release the valet switch.
You are now in the Start feature “D” programming mode.
Press and release the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default Setting
Two Chirps /
LED Two Pulse
Three Chirps /
LED Three Pulse
Four Chirps /
LED Four Pulse
1
Factory alarm disarm
with channel 3 on
Without This Feature
2
Constant Parking
Light Output Upon
Remote Start
Flashing Parking
Light Output Upon
Remote Start
3
20 Minute Run Time 30 Minute Run Time 10 Minute Run Time 5 Minute Run Time
4
Door lock After
Start (RUN)
Door Lock After
Shut-Down
Door Lock Before Start
and Door Lock After
Shut-Down
Without This Feature
5 +
Gasoline Engine
Diesel Engine
with Wait-To-
Start Light
(White/Green
ire must be
connected)
Diesel Engine
Without Wait-To-Start
Light 10 Second
Warm-Up Timer
Diesel Engine
without Wait-To-Start
Light 15 Second
Warm-Up Timer
Diesel Engine Without Wait-To-Start
Light 20 Second Warm-Up Timer
6
+ Press
Button =
Activate
Remote Start
Press - button
= Activate Remote
Start
Press + button
= Activate Remote
Start
7 +
Thick Pink =
Ignition 2
Thick Pink = Start 2 Thick Pink= ACC 2
8
+
No Function
Pulse Yellow Ignition
1 Before Unlock
Exit: Turn Ignition to “ON” position, or leave it for 15 seconds. 3 long chirps & 3 parking light ashes will conrm exit.