Silencer 65SL - Start Feature E Programming; Rpm Learning

IM_FULL_65SL_REV-A 17
START FEATURE “E” PROGRAMMING
Turn the Ignition ‘switch ‘ON/OFF’ 3 times and stay in the “OFF” position.
Push the Valet switch 7 times (holding in on the 7th push) until one long chirp is heard and then release the valet switch.
You are now in the Start feature “E” programming mode.
Press and release the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default Setting
Two Chirps /
LED Two Pulse
Three Chirps /
LED Three Pulse
Four Chirps /
LED Four Pulse
1
+
Voltage Check Type (B)
Tachometer
Check Type (A)
Timer Checking Type (B) Data Bus Interface Mode**
2
A> RPM learning – see RPM Learning below.
B> Start Crank Time:
0.6-second
0.8-Second (2 Chirps), 1.0-Second (3 Chirps), 1.2-Second (4 Chirps),
1.4-Second (5 Chirps), 1.6-Second (6 Chirps), 1.8-Second (7 Chirps),
2.0-Second (8 Chirps), 3.0-Second (9 Chirps), 4.0-Second (10 Chirps),
3
Start or Stop the System for TESTING & ADJUSTMENTS
4
Low check level Hi Check Level
5
+
+ 50 RPM
DBI ONLY
No RPM
Learning
6
+
- 50 RPM
DBI ONLY
No RPM
Learning or
< 50 RPM
7
+
Automatic
Transmission
8
+
“TEST” Mode for Zone 2
/ Instant Trigger & Zone 3
/ Door Trigger
“TEST” Mode
for Zone 1
& Zone 4 (2
Stage Shock
Sensor)
Exit: Press the button on the transmitter. 3 long chirps & 3 parking light ashes will conrm exit.
RPM LEARNING
Note: To set RPM learning, the White/Red wire from the 16 pin connector must be connected properly.
1. Enter Start Feature “E” Program mode.
2. Press the + buttons together to set “Tachometer Checking Type” on (2-chirps).
3. Press the button to conrm RPM learning mode on (1-chirp).
4. Start the vehicle with the ignition key. While the engine is running the parking lights and LED will ash. If they ash,
proceed to point 5. If they do not ash, turn the ignition key to the OFF position and press the button to exit “E”
programming mode. Check or re-connect the White/Red wire from the 16 pin connector and re-try.
5. Press and hold the valet button (2-3 sec) until a long chirp is heard and the LED stays on solid for 2 seconds.
The RPM signal learning is complete.
6. Stop the engine using the ignition key.