Silencer 65SL - Page 18

IM_FULL_65SL_REV-A 18
RETURN TO START FEATURE FACTORY DEFAULT SETTING:
Press the button once and then press + buttons together for 6 seconds. There will be a reset conrmation of
3 long chirps and 3 parking light ashes. Ths conrms that programmable feature settings in charts “D” and “E” are
back to their default settings.
CHECK LEVEL PROGRAMMING: (TEST AND ADJUST)
1. Press the button once on the transmitter to start the vehicle.
2. If everything goes well:
a. Press the button once on the transmitter to stop engine running. You have successfully
completed this programming.
b. Press the button on the transmitter to exit the program mode. There will be 3 long chirps & 3 parking
light ashes for conrmation.
3. If the crank time is too long, (Engine already successfully running, but still cranks):
a. Press the once on the transmitter to stop engine running or press brake pedal. Press the button on
the transmitter to set proper “Check Level ” to Low position. 1 LED ash and 1 chirp will conrm this setting.
b. Repeat steps 1 – 4 if necessary.
4. If the crank time is too short, (Engine not running, crank stopped before starting):
a. Press the button once on the transmitter to stop engine running.
Press the button on the transmitter to set proper “ Check Level ” to Hi position. 2 LED ashes and 2 chirps
will conrm this setting.
b. Repeat steps 1 – 4 if necessary.
VOLTAGE CHECKING TYPE
1. Turn the Ignition switch “ON/OFF” 3 times and stay in the “OFF” position. Default setting
2. Push the Valet switch 7 times and hold it on the 7
th
push until a long chirp is hearing then release the valet switch.
3. Press the transmitter and buttons at the same time to set the “Voltage Checking Type”. 1 LED ash and 1 chirp
to conrm this setting.
Once you have completed step 3, you can adjust and test “Start Timer” as below:
START CRANK TIME PROGRAMMING
1. Press the button once on the transmitter to start the vehicle.
2. If everything goes well:
Wait for 15 seconds:
a. If the engine still running.
I. Press the button once on the transmitter to stop engine running.
You have successfully completed this programming.
II. Press the button on the transmitter to exit the program mode.
There will be 3 long chirps & 3 parking light ashes for conrmation.
b. If the engine shuts down after the vehicle has been started.
I. Press the button once on the transmitter to stop engine running.
II. Press the button on the transmitter to set “Check Level” to LOW position.
1 LED ash and 1 chirp to conrm this setting.
III. Repeat steps 1 – 2.