EasyManua.ls Logo

Silent Partner EDGE LITE - Remote Control (Star Only); Remote Control Operation; Caring for Your Machine; Maintenance Procedures

Silent Partner EDGE LITE
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
REMOTE CONTROL (Star only)
The Silent Partner STAR is supplied with a two-function remote control that operates ball FEED (on/off)
and SWEEP (on/off).
1. The FEED function only works when the machine is
turned on at the control panel and the FEED rate is set
above zero.
2. The SWEEP function only works when SWEEP is
turned on at the control panel.
The remote control resets itself every time the machine is
turned off. The reset default is with FEED and SWEEP in the
"ON" position so that the machine can be used in the absence
of the transmitter.
A common cause of poor remote performance is a weak
battery in the hand-held unit. Because of excessive shipping
costs, the factory does not supply replacement batteries for the
remote control unit. You can obtain these batteries from your
local electronics store.
This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following two conditions: 1. This device may not cause
harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
CARING FOR YOUR MACHINE
MAINTENANCE
The Silent Partner requires very little maintenance. The bearings for all motors are lubricated for life and
no electronic adjustment is required. Maintenance consists primarily of the following preventative
measures:
1. Remove dirt from inside the machine by reaching inside through the ejection hole and wiping the
base with a damp cloth.
2. The propulsion wheels are covered with a rubber dressing that does not require maintenance.
Grime from the balls will get deposited on the surface of the wheels, but it is not necessary to
remove it. If you wish to clean the surface of the wheels, you can scrub them with the scrubber
side of a kitchen sponge, using soap and water or, for a stronger action, using nail polish remover
(acetone).
3. When properly cared for, the internal battery that powers the machine has a life span of 2 to 4
years, after which it needs to be replaced. Care for your battery by stopping play when speed drops,
recharging the battery as soon as practical, and keeping it topped up. AC-powered machines do not
have an internal battery.
The remote control transmitter’s battery (STAR) needs to be replaced periodically. You can obtain these
batteries from your local electronics store.

Related product manuals