14
Using the nail polisher
Risk of damage to property!
The nail polisher is designed for short oper-
ation not exceeding 20 minutes. Using the
nail polisher continuously for more than 20
minutes could damage it.
• Then let the nail polisher cool o for at
least 15 minutes.
1. Clean your nails before using the nail polisher on them.
2. Attach the desired roller to the axle
2
of the nail polisher (see
g. A and F).
3. Push the release button
4
on the On/O switch
5
down (see
g. A and G).
4. Push the On/O switch up to switch the nail polisher on.
5. Without applying pressure, move the nail polisher across the nail
you would like to treat (see g. H).
In the process, only move over your nails for one to two seconds
and then check the result.
6. If you are done treating your nails or if you would like to take a
longer break, switch the nail polisher o by pushing the On/O
switch down (see g. I).
Tip: If you have smoothed your nails rst, you can now polish
them. For this, change the roller as described in the chapter
“Changing the rollers”.
After you are done with your nail care, clean the nail polisher as
described in the chapter “Cleaning”.
Also observe our notes in the chapter “Tips for proper use”.
To Next Page
Loading...