What to do if the compressor will not run on my Silver King Dispenser?
If the compressor of your Silver King Dispenser isn't running, here's what you can check: * Ensure the power switch is in the “On” position. * Verify the service cord is properly inserted into the wall receptacle; if not, replace it. * Check the circuit breaker or fuse.
Why does the compressor run constantly on my Silver King SKMCD1P/C1?
If the compressor in your Silver King Dispenser runs constantly, try these steps: 1. Adjust the temperature control, as the temperature might be set too low. 2. Reduce the room temperature or relocate the dispenser if the room temperature is abnormally high. 3. Check if the door or lid gaskets are sealing properly. If not, adjust them.
How to fix a beverage leaking or not flowing from my Silver King Dispenser?
If your Silver King Dispenser is leaking beverage or the beverage is not flowing, it might be due to a kinked tube. To fix this, remove the valve and pull the tube straight through the valve area. Another cause might be a stuck valve. In this case, you should clean the valve and valve area.
General| Model | SKMCD1P/C1 |
|---|---|
| Type | Milk Dispenser |
| Refrigerant | R134a |
| Temperature Range | 33°F to 41°F |
| Door Type | Stainless Steel |
| Power Supply | 115V/60Hz |
| Voltage | 115V |
To Next Page
