■ 10
│
GB
│
IE
│
NI
SKHK 40 A1
Handling and operation
Switching the headphones on/off
♦ Press the button
6
for about 2 seconds to switch on
the headphones. You will hear a beep and the operating/
charging LED
0
lights up violet for approx. 2 seconds. The
operating/charging LED
0
then flashes alternately orange
and blue.
The headphones are now in pairing mode.
♦ To switch off the headphones, press the button 6
again for about 2 seconds until you hear a beep and the
operating/charging LED 0 goes out.
Wearing the headphones
♦ When putting the headphones on, please note the markings
“R” (right) and “L” (left) on the inside of the adjustable head
band 1.
♦ Adjust the headband
1 so that it fits your head comfortably
and the earpieces 2 cover your ears.
Pairing/unpairing the headphones with a
Bluetooth
®
device
Before you can use the headphones with the Bluetooth
®
function,
you must pair them with a compatible Bluetooth
®
device.
♦ Switch on the headphones as described above to activate
pairing mode.
♦ Set the Bluetooth
®
playback device so that it scans for
Bluetooth
®
devices. A detailed description of how to do this
can be found in the operating manual for your Bluetooth
®
playback device.
♦ Select the entry SKHK 40 A1 from the list of devices found
on your Bluetooth
®
playback device and, if required, enter
the code 0000 to connect the two devices. If the pairing
is successful, you will hear a rising series of beeps and the
operating/charging LED 0 flashes blue twice at 3-second
intervals.
To Next Page
Loading...
