GB
│
MT
│
61 ■
SSTME 600 A1
Operation
WARNING!
► The motor switches off automatically as soon as the blender 3 is removed
from the motor block 6 or the lid 2 is opened. In such cases it may be
easy to forget that the machine is still switched on. The motor will then start
unexpectedly as soon as the blender attachment 3 is fitted or the lid 2 is
closed again:
Therefore:
– Do not insert the power plug into the wall socket until the blender 3 is
filled and mounted with its lid fitted and closed.
– Before fitting the blender, always check to see that the appliance is
switched off or that the power plug has been removed.
– Switch the appliance off first, pull the plug out and wait until the motor
has come to a standstill before removing the blender 3 or opening the
lid 2.
Fitting and filling the blender
1) Rotate the blender 3 anticlockwise until the arrow T under the blender
handle is located above the
position. Remove the blender 3 from the
motor block 6 in a vertical, upward motion.
2) Remove the lid 2 by rotating it anticlockwise towards position
(see Fig 1)
until you can pull it upwards.
3) Fill the blender 3. Never exceed the MAX marking.
4) Press the lid 2 firmly down onto the blender 3. Close the lid 2 by turning
it clockwise to position
until it audibly engages (see Fig. 2). Ensure that the
pouring spout on the blender 3 is closed. The motor cannot start until the
lid2 is fitted flush.
Fig. 1 Fig. 2
5) Press the measuring cap 1 into the lid as far as the stop.
IB_331510_SSTME600A1_LB5.indb 61 29.06.2020 15:51:32
To Next Page
Loading...
