GB
│
MT
│
67 ■
SSTME 600 A1
Cleaning
DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block 6 in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
► Never insert your hand or fingers into the blender 3, especially while it is
in use. The cutting blades 4 are extremely sharp!
CAUTION! PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
Cleaning the blender
■ To prevent injuring yourself on the cutting blades 4, clean the blender 3 only
with a long-handled washing-up brush.
■ Clean the measuring cap 1 and the lid 2 in mild soap solution. Ensure that
the rubber seal 9 is correctly fitted before using the lid 2 again.
NOTE
You can also clean the lid 2, the measuring cap 1 and the
blender3 with the cutting blade 4 in your dishwasher.
■ If you clean the appliance directly after use, you can usually achieve
sufficiently hygienic cleaning results by using the following alternatives:
Fill the blender 3 with 750 ml of water and add a couple of drops of mild
washing up liquid. Close the lid 2 and fit the blender 3 onto the motor
block 6. Insert the mains plug into the socket and activate the pulse function
a few times so that the cutting blades 4 plough through the water at maximum
speed. Afterwards, rinse the blender 3 with plenty of clean water to remove
any washing up liquid residues.
■ To remove stubborn dirt, you can remove the attachment
A
with the cutting
blades 4 from the blender jug 3:
IB_331510_SSTME600A1_LB5.indb 67 29.06.2020 15:51:39
To Next Page
Loading...
