■ 68
│
GB
│
MT
SSTME 600 A1
A
B
Fig. 3
1) Remove the blender 3 from the motor block 6. For better stability, remove
the lid 2 by turning it anticlockwise towards the position
(see fig 1)
until you can pull it off upwards.
2) Turn the appliance upside down and turn the attachment A with the cutting
blades 4 anticlockwise so that it can be detached from the blender jug3
(see fig. 3).
WARNING! RISK OF INJURY!
► Handle the cutting blades 4 with extreme caution. They are very sharp.
3) Clean both parts thoroughly in a mild soap solution.
NOTE
If necessary, you can remove the sealing ring B from the attachment A with
the cutting blades 4. Pull the sealing ring B out of the attachment A and
clean it in a mild soap solution. Then rinse off the sealing ring B in fresh
water.
IB_331510_SSTME600A1_LB5.indb 68 29.06.2020 15:51:40
To Next Page
Loading...
